Epoxy Resin Floor Coating Auxiliary Products (III) – Oil Stain Remover

It is not easy for the interface to get rid of stains and oil pollution completely. As an auxiliary product of epoxy resin floor coating oil stain remover, this product can effectively remove stubborn stains on the floor of car garage, driveway, patio, canal, staircase, etc. It is especially suitable for concrete and masonry surfaces, etc. The high proportion of active ingredients in the solvent can excellently remove oil stains and perfectly repair the interface of the substrate.

Product Description
It is a water-soluble amber-colored liquid designed for the removal of severe grease stains. During the cleaning process, it can emulsify greasy stains into soap, and the cleaned surface can be easily rinsed with water, especially suitable for cleaning the concrete interface.

The basic characteristics
Removes heavy grease stains from the interface; water-soluble material, non-toxic product; the best means of interface repair before coating construction; perfect removal of all kinds of old and new stains; greatly enhances the adhesion of the coating; highly concentrated liquid; high proportion of active ingredients.

The overall comments
Whereas previously degreasing products could only remove superficial floating stains, they now emulsify the stains and then wash them away completely, giving the surface coating the cleanest possible construction substrate.

The use of objects
Indoor and outdoor concrete interface, asphalt interface, brick and gray surface, masonry surface, tile surface, wooden surface, metal surface, exposed real stone surface and exposed building mixture surface (such as concrete and gravel combined surface), etc..

Construction preparation
Before construction, carefully sweep the surface layer of floating debris, scrape off the floating layer of grease and oil. Use plastic film to cover the surface vegetation or mulch that should be protected. For plants should be thoroughly watered with water before covering.

Construction operation
Sprinkle the solution evenly onto the construction surface with a brush or a plastic can, and leave it for 20 minutes to make it fully penetrate.
Use strong hard floor brush to do hard brushing and scraping of the surface layer, and then connected to a soft water pipe with a nozzle to rinse thoroughly with water, for difficult to clean the place can be repeated in the same way, until completely clean.
After cleaning, all kinds of oil stains will be greatly reduced or completely disappeared. But for some old and deep oil stains may have to be cleaned several times before they can be completely removed.

Unit Consumption
A maximum area of 50 square feet (4.65 square meters) can be cleaned per gallon, depending on the water/solution dilution ratio, severity of ground contaminants, and leakage.

Technical data
Percentage of active ingredient: 75; Viscosity: 65 K.U.

Cautions
Do not mix with other chemical solutions, do not take orally, and do not store at special temperatures.
In case of accidental ingestion, do not induce vomiting, should promptly ask a doctor to deal with.
Eyes and skin contact should be avoided, otherwise it will feel uncomfortable.
If indeterminate factors after careful contact, should be rinsed with water for about 10 minutes, if still feel uncomfortable, can promptly call a doctor to deal with.

More YQXPOLYMER Epoxy Resin information, please contact us via email: sales@yqxpolymer.com, or voice to us at: +86-28-8411-1861.

Some pictures and texts are reproduced from the Internet, and the copyright belongs to the original author. If there is any infringement, please contact us to delete.

Related Post

Scroll to Top
Scroll to Top